The metal shaper man's blog http://www.metalshaperman.com Life is a journey in the general direction of an eventual destination.. Wed, 08 Sep 2010 11:27:42 +0000 http://backend.userland.com/rss092 en DXF Kiss Cut challenges/ using a vibro-etcher to cut card stock. http://www.metalshaperman.com/?p=315 Doing a little pop-up card research http://www.metalshaperman.com/?p=296 Road trip results on the heekscad dxf to pazzle inspiration experiment. http://www.metalshaperman.com/?p=292 Trying out heekscad for my pop-up card project http://www.metalshaperman.com/?p=284 More foundation work on the Pop-up project http://www.metalshaperman.com/?p=276 More on my pop up card project. http://www.metalshaperman.com/?p=273 Playing Around with Paper Engineering Pop ups http://www.metalshaperman.com/?p=267 Trying to figure out where this Scooba 5900 part goes http://www.metalshaperman.com/?p=258 Playing around with heekscad again http://www.metalshaperman.com/?p=251 Trying to get the codelite debugger to work in Ubuntu linux http://www.metalshaperman.com/?p=248