zwei fliegen mit einer klappe. DIY Sherline CNC retrofit and learning Freecad

Time for bed.. Lets see if I can sum it up shortly.. Got the CNC Sherline in barter.  Turned out that third party CNC conversion was slock.  (Basically slapped Steppers over manual washer bearing setup.)  Too cheap to buy the Sherline conversion kit.  Need a project to work on Freecad..

So… Here’s the progress:







So I’ve created the  extrusion.

Next steps

  • pop 4 counter bored holes in to support the base to foundation
  • 2 counterbored holes to support the column
  • Machining of extrusion by the column support
This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *