Author Archives: admin

I’m thinking I’m going to have the printer running in a day or so… I got everything wired up I just need to assemble the extruder head.  One thing that I didn’t have was a small piece of ptfe to … Continue reading →

I had a leak in my printer using a  tube a made myself for my qu-bd printer head and I wanted to see if I could rework it.  The was some eccentricity present between the 45 degree chamfer and the … Continue reading →

I wanted to see what happened on why my mod failed. I had made  fixture to turn my blanks.  Basically put a piece of 3/4 bar in the collet chuck of my lathe and then single point bored it for … Continue reading →

We’ll for PLA the qu-bd mbe stock design leave much to be desired, but I must say they ship spare parts  darn fast.  I placed and order for a heater and a few spare nozzles and it shipped same day.  … Continue reading →

I had done  a bunch of retrofits to my qu-bd printer, the last of which was installing a  PTFE liner, from the rework here. buildlog.net • View topic – 15 min fix for jam free QU–BD .   This fix worked … Continue reading →

I had gotten about 20-30 hours out of the last modification and I than I had a extrusion failure. Initially, I thought I thought, the failure was the pla seizing on the nut holding the hollowed out M6 threaded rod … Continue reading →

I finally got my printer working nicely..  I’ve been using a heavily modified qu-bd extruder.I hobbed my own gear wheel and did the modification where a bearing presses against the filament which presses against the gearwheel.  The problem that I’d … Continue reading →

So.. I found this guide to calibration so I thought, I work through it.– http://reprap.org/wiki/Triffid_Hunter%27s_Calibration_Guide X-Y steps. I’m using belts/pulleys that I had picked up from inventables. https://www.inventables.com/technologies/mxl-belting-open-ended https://www.inventables.com/technologies/plastic-mxl-pulley-dual-flange X-Y steps = motor_steps_per_rev * driver_microstep / belt_pitch / pulley_number_of_teeth So… … Continue reading →

To anyone reading this, my apologies on the roughness of these notes…  I’m sure there’s plenty of typo’s grammar mistakes.  I was sort of time-strapped when I did this. It was sort of irritating that I had to reformat my … Continue reading →

Back from vacation…   So..  I wound up sending my ramps 1.4 back to Ultimachine and they fixed my problem.   They fixed it for me no-cost..   I’m suspecting it was part of my own stupidity that led to this failure,  so … Continue reading →